Operation
OVATION Min-E-10CW User Manual Rev. 3
-7-
4.
O
PERATION
Rotating the
Barrel Assembly
The OVATION Min-E-10CW allows manual rotation of the barrel assembly, as follows.
1. Locate the barrel rotation knobs at the top and bottom of the reflector housing.
2. Loosen the knobs by turning them counter-clockwise.
•
Note:
Do not remove the knobs.
3. Rotate the barrel to the desired position, in either direction from the centered position.
4. Tighten the knobs by turning them clockwise, which lock the barrel’s position.
When the gobo holder is installed, make sure the gobo holder slot cover is securing the
gobo holder into the gobo holder slot before rotating the barrel assembly or mounting
the product overhead.
Framing Shutters
Use the framing shutters to tighten and shape the beam of the OVATION Min-E-10CW, or open
them completely to allow the full beam to pass.
Gobo Holder Slot
The gobo holder slot has a sliding cover and is located in front of the top framing shutter. The
cover can either block the slot completely when the gobo holder is not inserted, or lock the gobo
holder in place. Use a phillips head screwdriver to loosen or tighten the cover.
Gobo Holder
The OVATION Min-E-10CW comes with a removable gobo holder. Care must be taken when
removing or inserting the gobo holder. Follow the guidelines below when changing gobos:
•
Always insert the gobo holder with the handle facing towards the front of the product.
•
Pull back the framing shutter assembly directly behind the gobo holder slot for easier
insertion and removal.
•
Do not insert the gobo holder backwards.
Barrel
Assembly/Gobo
Holder Diagram
Lens Tube
Manual Beam
Focus Control
The OVATION Min-E-10CW has a manual focus, which is adjusted as follows.
1. Locate the beam focus knobs at the side of the barrel assembly.
2. Loosen the knobs by turning them counter-clockwise.
3. Use the focus and zoom adjustment knobs to match the markings (19°, 26°, or 36°) on the
side of barrel to achieve a desired focus and beam angle.
4. Tighten the knobs by turning them clockwise, which will lock the lens into position.
Gel Frame Holder
The OVATION Min-E-10CW comes with a removable gel frame that fits into the holder on the
front of the lens tube. To open the gel frame holder, pull the sides of the clip to the left and right
and flip it up.
The frame can only fit into the holder with the opening facing down.
Rivet heads
Handle face
Gobo Holder Slot
Cover Screw
Gobo Holder Slot
Summary of Contents for MIN-E-10CW
Page 1: ...User Manual ...
Page 4: ......
