3. Take bolts (D) and place them into brackets (C) so that the bolts will stay locked with brackets (C).
4. Slide 2 brackets (C) with their bolts (D) into attachment rails with threads facing down. Do the same for the
second attachment rail.
5. Have two or more persons place the tent atop the vehicle onto roof rack or crossbars.
6. Once the tent is positioned, insert bolts (D) through bottom brackets (B), so that brackets (B) clamp the tent
against the rack or crossbars. Do NOT keep tightening after it has already started to bend as this will make it difficult
to mount again in the future.
IMPORTANT:
A
pply
lubricant
to
the
bolts
and
nuts
before
tightening
to
prevent
thread
galling.
7. Repeat the procedure for the remaining 3 brackets. NOTE: Check that the tent is securely attached after a short
distance, and thereafter at regular intervals. Tighten the mounting brackets whenever necessary.
INSTALLING
THE
LADDER
CAUTION:
FAILURE
TO
PROPERLY
SECURE
THE
LADDER
COULD
CAUSE
DAMAGE
AND
SERIOUS
INJURY.
CAREFULLY
READ
THE
INSTRUCTIONS
BELOW
BEFORE
ATTEMPTING
TO
USE
THE
LADDER.
The
ladder
acts
as
the
support
for
the
tent’s
extension
panel.
Always
make
sure
the
ladder
is
firmly
planted
in
the
ground,
and
each
step
is
securely
locked
before
going
up
the
ladder.
1.
Gather hardware (E)
2. Find four pre-drilled holes on one end of the tent
floor.
3. Install brackets into four pre-drilled holes using
the four nuts and bolts seen in picture.
4. Once brackets are secure, place ladder against
brackets with ladder stickers facing outwards.
5. Attach ladder to brackets using the two small
nuts and bolts seen in picture. NOTE: Make sure
all hardware is tight before ladder use.
