8 Use
8.1 Instructions for use
•
Attaching loads (e.g. backpacks) can adversely affect stability. Suspending additional loads on the wheelchair
is not permitted.
•
The recommended overall width for manual wheelchairs in an operational state is
700 mm
. This specification
should ensure unhindered use of escape routes, for example. Please note that the product dimensions can
exceed the recommended value in versions with very large seat widths (for more information see see Page 39
ff.).
•
The wheelchairs in this series fully satisfy the minimum technical requirements for wheelchairs transportable by
train. However, please note that it is possible that not every individual wheelchair will fulfil the minimum require
ments due to the variation in designs (please see see Page 40 for further details).
8.2 Getting in and transferring
CAUTION
Incorrect handling when getting in
Risk of falling, tipping or rolling away due to incorrect handling
►
Activate the wheel lock each time before you get into or out of or transfer to or from the wheelchair.
►
Always get into the wheelchair from the side, where possible.
►
Never step on the foot plates when getting in and out.
►
Do not support yourself on the wheel lock when getting in/out.
CAUTION
Incorrect caster wheel position when leaning forward in the wheelchair
Tipping over, falling due to incorrect caster wheel positioning
►
Prior to activities that require you to bend forward in the wheelchair (e.g. tying your shoes), maximise the sta
bility of the wheelchair.
►
In order to do so, push the wheelchair backwards until the caster wheels turn forward.
Users can choose the method for getting into and out of the wheelchair which is most suitable for them. The
respective procedure should be discussed and practised with a therapist.
As a rule, the frame tubes, seat bottom or side panels can be used as supports for getting into the wheelchair.
If getting in independently is not possible, transferring or getting in always has to be performed with the help of an
assistant. The manufacturer also offers transfer aids for getting in, such as transfer boards.
8.3 Legrests
The legrests support the user's legs.
The height of the legrest has been adjusted by qualified personnel to the length of the user's lower legs.
The angle of the footrest has been set by the qualified personnel so that it allows the ankles to rest in a comfortable
position.
The calf strap offers additional support to the user's legs. It can be removed for cleaning.
Removing the leg support – segmented leg support
1) Fold the foot plate up.
2) Pull back the leg support release lever (see fig. 29, item 1).
3) Fold the leg support out
90°
(see fig. 30, item 1) and pull up to detach (see fig. 30, item 2).
Attaching the leg support – segmented leg support
1) Hold the leg support
90°
out to the side and insert it into the leg support retainer (see fig. 30, item 1/2).
2) Swing the leg support into the direction of travel until it engages.
3) Fold the foot plate down.
21
Start B2
Use
Summary of Contents for Start B2
Page 1: ...Start B2 Instructions for use 3 ...
Page 2: ...2 Start B2 ...
Page 42: ...Start B2 42 ...
