NOTICE
Use of unsuitable packaging
Damage to the product caused by transportation using incorrect packaging
►
Use only the original packaging for delivery of the product.
6.3.1.2 Adjusting the standard seat
6.3.1.2.1 Adjusting the seat angle
CAUTION
Improper adjustments
Falling of the user out of the seat due to user error
►
The user must not sit in the wheelchair during seat angle adjustments.
If necessary, the seat angle can be adjusted in 3 increments (-6°, +3° and +12°).
4
Adjusting the seat angle on the standard seat
1) Loosen both Allen head screws located at the front
below the seat (see fig. 4).
2) Set the desired seat angle by placing the pin in the
corresponding hole.
3) Re-tighten the Allen head screws after making the
adjustment.
4) Check that the retaining clip on the pin is closed
every time after the seat angle is adjusted.
The seat angle can be changed using the seat tilt function if the power wheelchair is equipped with seat tilt (power
seat tilt: see Page 40; mechanical seat tilt: see Page 43).
6.3.1.2.2 Adjusting the leg supports
The legrests can be subsequently adjusted to the requirements of the user.
5
Longitudinal adjustment of the footrest receiver
Telescoping the footrest receivers in the longitudinal
direction is possible in pairs:
1) Remove the seat cushion, legrests and side panels.
2) Loosen the Allen head screws on both sides of the
seat frame (see fig. 5).
3) Adjust the depth of the footrest receivers to the
desired position.
4) Firmly re-tighten the Allen head screws on both
sides of the seat frame.
5) Put on the seat cushion, and reinstall the legrests
and the side panels.
16
Preparing the product for use
Skippi Plus
