Otto Bock HR2233-0000 K, Instructions For Use Manual

Page: 20 / 92

4 Delivery
4.1 Scope of delivery
The following components are included in the original package:
•
Chassis
• Slide-in module with tilt adjustment mechanism
• Instructions for use and required tools
• Push handle (accessory)
4.2 Storage
The product must be stored in a dry place. An ambient temperature between
-10 °C and +40 °C
must be main­
tained.
It is not necessary to disassemble or fold up the product.
5 Preparation for use
5.1 Assembly
INFORMATION
► This section describes the simple assembly of the indoor mobility base only. Please note the specifications
regarding the seat height adjustment (see Page 22), setting the seat inclination (see Page 23) and setting the
anti-tipper (see Page 23). If required, carry out these settings at the same time as the assembly.
►
To install the push handle option: see Page 24.
Installing the basic frame
1) Remove the transport locks and packaging material.
2) Loosen and remove the screws on the basic frame (see fig. 1, item 1).
3) Slide the adapter into the basic frame and use the screws to attach it to the basic frame (see fig. 2, item 1; see
fig. 1, item 1).
INFORMATION: In doing so, please note that the hole for the tripod spring is on the left side with
respect to the direction of travel (see fig. 2, item 2; see fig. 3, item 1).
1 2
20
Delivery
HR2233=0000_K