
Important information for the products 3B1/3B1=ST
The functional scope of products with serial numbers SN 2015 25 XXX and higher, or products
that have been serviced or repaired by an authorised Ottobock Service Centre since June 2015,
has been extended.
Extended functional scope:
•
Switching to pre-configured MyModes and changing the prosthesis settings by using the
remote control or an app for smartphones (4X441 Cockpit) (see Page 75, see Page 85). If the
joint bears the marking "DUAL", the remote control cannot be used anymore (see next sec
tion).
•
Possibility of using an intentional stance function (see Page 80)
•
Displays of the current battery level without additional devices (see Page 74)
•
Deactivation of feedback and vibration signals (mute mode – see Page 88)
•
Stance, sitting, and stairs function can be switched off (see Page 85)
•
Bluetooth function can be switched off (see Page 87)
INFORMATION
Remote control function only possible with version 1.0.0.6 or above
Please note that you can only use this knee joint and the updated one with the
4X350 remote
control in version 1.0.0.6 and higher
.
Therefore, check the version of the remote control as follows:
►
With the remote control switched on, use the and keys to select the menu option
RC
settings
and confirm with the key.
►
Use the and keys to select the menu option
Info
and confirm this with the key.
►
Use the and keys to select the
RC version: 1.0.0.4
menu option. If an older version
appears than
1.0.0.6
, the remote control must be updated by an authorised Ottobock Ser
vice Centre.
The function of the remote control with this or the updated knee joint is only pos
sible with version 1.0.0.6 or higher.
Important information for the products 3B1/3B1=ST and 3B1-2/3B1-2=ST
INFORMATION
Adjustment of the knee joint possible only with X-Soft 4X1 version 1.8 and higher
Please note that you need X-Soft 4X1 version 1.8 or higher in order to adjust this knee joint or
the updated one. If X-Soft version 1.0 or higher is available, it can be updated (Alignment)
60