Otto Bock Genium 3B1-2, Instructions For Use Manual

Page: 69 / 480

69
8.2 Initial connection between cockpit app and prosthesis
The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to estab­
lish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 79).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
•
The device must be connected to the internet.
• The serial number and PIN code of the component being connected must be known. They are
found on the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the PIN card and serial number of the component is lost, contact
your prosthetist.
8.2.1 Starting the cockpit app for the first time
1) Tap the symbol of the Cockpit app ( ).
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the
Accept
button. If the end user
license agreement (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Tap the
Add component
button.
→ The "
Preparation
" screen appears. The serial number of the component should be
entered here.
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the symbol
appears.
The
symbol is displayed when the connection has been established.
→
Once the connection has been established, the data are read from the component. This pro­
cess may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully, the app will
connect automatically each time it is started. No further steps are required.