Otto Bock Dino 3, Instructions For Use Manual

Page: 11 / 32

→ Installation of the anti-tipper is complete.
For individual adjustment of the anti-tipper, see the section “Adjusting the anti-tipper” (see Page 23).
4 5
7 Settings
7.1 Prerequisites
WARNING
Making incorrect adjustments
Tipping over, falling or malposition of the user due to incorrect adjustments
► Adjustment and assembly work may be carried out only by qualified personnel.
► Only the adjustments described in these instructions for use may be carried out.
►
Settings may only be changed within the allowable adjustment ranges; otherwise, the stability of the product
may be impaired (see this section and the “Technical data” section). If you have questions, contact the
manufacturer’s service department (see inside back cover for addresses).
► Only conduct tests in the presence of an assistant.
►
Unless expressly described, you may not change any settings with a person sitting in the product.
► Secure the user against falling out during all tests.
►
Before testing setting changes with the user seated, firmly tighten all screw connections.
► Check for safe function before delivering the product.
WARNING
Lack of stability against tipping
User may fall or tip over due to lack of inspection
► Changing the settings can lead to instability of the system as a whole. Verify tipping resistance after any
changes to the settings.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
► Always firmly re-tighten the mounting screws and nuts after changing settings. Observe the specified torques
in doing so.
►
Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite 241).
► Always replace self-locking screws and nuts with new self-locking screws and nuts after disassembly.
11 Dino 3
Settings