Otto Bock C-Leg 3C98-3, Instructions For Use Manual

Page: 68 / 280

68 | Ottobock
Error message Cause Correction
A current connection to
the prosthesis was inter­
rupted Check the following points:
•
Distance from the prosthesis to the
device
• Battery charge level of the prosthesis
• Bluetooth on the prosthesis switched
on? (see Page 60)
• If multiple prostheses were stored in
the remote control, was the correct
prosthesis selected?
13.2.4 Status signals
Battery charger is connected
LED on
power
supply LED on bat­
tery charger Event
Power supply and battery charger operational
Battery charger disconnected
Beep
signal Vibration
signal Event
1x short 1x short Self-test completed successfully. Product is operational.
3x short Maintenance note
Conduct the self-test again by connecting/disconnecting the battery
charger. If the beep signal sounds again, visit your prosthetist soon. If
necessary, the prosthetist will forward the product to an authorised
Ottobock Service Centre.
The product can be used without restrictions. However, vibration signals
may not be generated.
Battery charge level
Battery char­
ger
Battery is being charged, battery charge level is less than 50%
Battery is being charged, battery charge level is over 50%
Battery is fully charged (or connection with product is interrupted).
Take note of the beep signals to differentiate between these states.
When the battery charger is connected or disconnected, a self-test is conduc­
ted and confirmed by a single beep and vibration signal.
The battery is fully charged if this beep signal is heard.
If no beep signal is heard, the connection to the product is interrupted.
13.3 Technical data
Environmental conditions
Storage and transport in original packaging
(≤3 months) -20°C/-4°F to +40°C/+104°F