2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 5, item 1) in or out.
5
6.2.5 Adjusting the handrims
INFORMATION
This section does not apply to standard wheels.
All handrims are designed for a spacing from the drive wheel of
15 mm
(standard setting) and
25 mm
.
1) Loosen/remove the handrim screw connection from the rim (see fig. 7).
2) Tightly screw the handrims onto the rim in narrow or wide installation position.
6
7
6.3 Adjusting the caster wheels
6.3.1 Adjusting the caster journal angle
When the drive wheels have been adjusted for the user, the caster journal angle must be adjusted at the caster
wheel adapter.
The threaded axle in the caster wheel adapter should be perpendicular to the ground to ensure optimum rolling
behaviour of the wheelchair. The caster wheel adapter permits a continuous adjustment of this angle.
1) Remove the caps from the caster wheel adapters (see fig. 8, item 1).
2) Slightly loosen the Allen head screws on the inside of the frame (see fig. 8, item 2).
3) Slightly loosen the Allen head screw on the eccentric (see fig. 8, item 3).
4) Position the assembly aid (spirit level) (see fig. 9, item 1).
5) Adjust the positive/negative caster to
90°
on the eccentric disc using a large flat screwdriver. The assembly aid
(spirit level) must be in the centre position (see fig. 9, item 2).
6) Tighten the Allen head screw on the eccentric to
8 Nm
(see fig. 8, item 3).
7) Tighten the Allen head screws on the inside of the frame to
23 Nm
(see fig. 8, item 2).
→
The threaded axle on each of the two caster wheel adapters must be positioned vertically.
12
Settings
Avantgarde Teen2 T,
Avantgarde Teen2 VR
Summary of Contents for Avantgarde Teen2 T
Page 1: ...Avantgarde Teen2 T Avantgarde Teen2 VR Instructions for use qualified personnel 3...
Page 2: ...2...
Page 29: ...29...
Page 30: ...30...
