Otto Bock Avantgarde CLT, Service Manual

Page: 25 / 64

3.9 Assembly D: back/push handle
3.9.1 Replacement Work on the Push Handles
All push handles are installed on the upper end of the back tubes.
3.9.1.1 Replacing the "standard" push handles
1) Unscrew/remove both size 5 Allen head screws on the back tube (see fig. 71).
2) Remove/replace the push handle off the back tube (see fig. 72).
3) To reassemble, perform these steps in reverse order.
71 72
3.9.1.2 Retrofitting the "height-adjustable" push handles
1) Remove the old push handle.
2) Push the height-adjustable push handle into the back tube (see fig. 73).
3) In the upper hole screw the clamping lever onto the clamping lever slide block (see fig. 74).
73 74
3.9.1.3 Retrofitting the "height-adjustable/removable" push handles
1) Remove the old push handle.
2) Slide the "height-adjustable/removable" push handle onto the back tube.
3) Insert the installation adapter into the back tube (see fig. 75).
4) Bolt the installation adapter together with the push handle (see fig. 76).
25 Avantgarde CV / CS / CLT
Service Work