Important additional information
The ConnectLine wireless microphone contains a radio trans-
mitter using a frequency hopping technology working in the
ISM-band at 2.4 GHz.
The peak conducted output power of the transmitter is less
than 6 dBm and the antenna is a small PCB antenna with a
directional gain of less than 2 dBi (dB over an isotropical or
omni-directional antenna).
The emission power from the Connectline Microphone is below
international emission limits for Human Exposure. For com-
parison, the radiation of the Connectline Microphone is less
than unintended electromagnetic radiation from for example
hair dryers, electric shavers etc. The Connectline Microphone
complies with international standards concerning Electromag-
netic Compatibility.
USA and Canada
Due to the limited size available on the device, many of the
relevant approval markings are found in this document.
This instrument is certified under:
FCC ID: U28MIC110
IC: 1350B-MIC110
The device complies with Part 15 of the FCC rules and
RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
This device may not cause harmful interference. This device
must accept any interference received, including interference
that may cause undesired operation.
Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Not a toy
The Connectline Microphone is not a toy and therefore should
be kept out of the reach of children and anyone else who might
swallow parts or otherwise cause injury to themselves. Special
attention should be paid to the smaller components in order to
prevent children from swallowing them and choking. If a part is
swallowed, see a doctor immediately.
Use on aircrafts
The Connectline Microphone should not be used onboard air-
crafts unless specifically permitted by the flight personnel.
Active Implants
Oticon shows caution and advise to follow the guideline as
recommended by manufacturers of implantable defibrillators
and pacemakers regarding use of mobile phones. If you wear
an active implant, then keep the microphone more than 15 cm
away from the implant.
Do not expose to great heat
Never exposure the Connectline Microphone to great heat by
putting it in the oven, micro wave oven or burning it. There is a
risk that it will explode and cause serious injury.
Cleaning
Oticon recommends cleaning on a regular basis, using a
damp cloth witout solvents.
Do not immerse Connectline Microphone in water or other
liquids.
Only charge from UL/IEC approved equipment
The safety of recharging batteries with the USB connector
only is determined by the external equipment. When the
USB connector is connected to mainsoperated equipment, this
equipment should be UL approved or comply IEC 60950, IEC-
60065, IEC-60601 or equivalent safety standards.
Use of the Lanyard
If by accident the lanyard should get caught on something
while wearing it, the lanyard is constructed to release.
Therefore, never try to shorten or modify the lanyard in an
unauthorized way. The lanyard should not be used for children
who weights less than 11 kg.
Explosives
The power source in your microphone has insufficient energy
to cause fire in normal conditions of use. The microphone has
not been tested for compliance with international standards
concerning explosive atmostpheres. It is recommended not to
use your hearing instruments in areas where there is a danger
of explosions.
Products complying with R&TTE:
When using the ConnectLine michrophone in Norway it must
be ensured that no radio transmission is performed within a
20 km radius from the center of Ny-Aalesund.
X-ray, CT, MR, PET scanning and electrotherapy
Do not wear the microphone during X-ray, CT / MR / PET
scanning, electrotherapy or surgery.
IMPORTANT NOTICE
Please familiarise yourself with the entire contents of this
booklet before using your Connectline Microphone. It con-
tains instructions and important information about the use
and handling of your Connectline Microphone.
Warnings
1 min
6 secs
6 secs
People First is our promise
to empower people
to communicate freely,
interact naturally and
participate actively
People First
INSTRUCTIONS
FOR USE
MICROPHONE
STREAMER PRO
Pairing / initial setup (only needed once)
Charging / power indicator
The microphone should point towards the speaker’s mouth and be
within a distance of 10 to 20 cm.
The Microphone will transmit the speech from the Speaker directly
to the Hearing instrument user.
Note: A Microphone will only work with one Streamer at a time
Status indicator
(orange)
Microphone input
(Voice)
Power indicator
(green)
On/off button
Microphone input
(noise detector),
do not cover
Battery Charge connector
(mini USB)
Battery Low
Maximum 20 min.
speaking time left
Charging
Fully charged
(After approx. 1.5
hours.) Will last for
approx. 5 hours use.
2. Microphone in pairing mode
Press and hold for 6 seconds until orange
Light flashes rapidly
1. Streamer Pro in pairing mode
Hold until blue
light flashes
Orange light is flashing
rapidly in pairing mode
Press
3. Microphone paired
Wait up to 1 minute until Streamer light
is orange and microphone light is orange
What’s in the box?
Product overview
Speaker
Wearing
with Clip
Constant
red light
Wearing with
Lanyard
Blinking
green light
Incorrect
usage
Constant
green light
Hearing Instrument user
Microphone
Power supply (charger)
This manual
Important
Information
Lanyard
Carry pouch
14
43
01
U
S /
0
4.
14
How the Microphone works
To charge the microphone, connect the power supply cord to
the mini USB connector at the bottom of the microphone.
Turn page
Page 1
Up to 15 meters
