MAX.
MIN.
(A)
(B)
46 User manual
Clutch cover (D)
Ignition cover (C)
The oil level should be checked when the motor-
cycle is in an upright position and on a at surface.
The motorcycle should be cold. If it is not cold,
wait some minutes until it goes cold.
Checking the crankcase oil
Filling and draining the crankcase
Crankcase oil is used for lubricating the change pedal and the
clutch. Check the oil level with the indicator located on the lower
part of the clutch cover, which is on the right side of the engine. The
oil level should be lower than the indicated maximum level.
Optimum oil level
To add oil, remove the cap (A) located on the top of the
clutch cover (D). Use a funnel to add the oil, NEVER fi-
lling above the Maximum level. Replace the cap. If you
fill above the Maximum level, oil must be removed. To
remove oil from the hood, place a receptacle under the
motorcycle and remove the lid (B) located on the side
of the hood, leaning the bike over in both directions to
ensure that no oil remains inside the hood.
IMPORTANT: Clean the plug and change the sealing washer
each time the oil is changed.
The crankcase has a 375cc oil capacity. 2T 100%
synthetic oil should always be used.
Indicator
Summary of Contents for Explorer
