Page
25
of
59
ENCODERS CH1, CH2, CH3
SET ENCODER SETTINGS
All settings for creating a stream can be found by clicking on the tab for the individual encoders labeled CH1, CH2
and CH3. To configure an encoder, it is best to start first with the “Destination” ribbon. Each type of encoder
transport has configuration options that are unique to that encoder type. By selecting the “Output Transport” first,
these options are activate
d on the subsequent “Video” and “Audio” ribbons.
START
All encoder options should be configured before clicking on the “Start” button.
DESTINATION
The Destination ribbon is where you select the transport type and location of the video stream you are creating.
The selection of the Output Transport will change the options available on the Destination page, as well as the
Video selections found on the next ribbon. For that reason, it is recommended that you start all configuration at
the Destination tab.
