10279-D01-00
Page 120 of 142
This information is the property of Oshkosh Specialty Vehicles and is considered to be confidential. The contents may not be used, either
partially or wholly, for any purpose inconsistent with which it was produced. This information may not be reproduced or disclosed without prior
express consent.
Temperature is out of specifications…
The desired room temperature is 72ºF. If the temperature is out of specifications, either too high or
too low, refer to the following table.
Problem:
Check for:
Solution:
1.
Check for exterior doors left
open during warm weather
conditions.
The HVAC system can only support
the environment of the mobile unit.
Unless opened for use, all exterior
doors should remain closed all of the
time.
2.
Check for blocked or dirty air
vents and/or air conditioner
filters.
Clean the air vents and/or change the
air conditioner filters. After this has
been done, verify that cold air is
blowing.
3.
Check to see if the A/C
disconnect is in the “OFF”
position.
Turn the A/C disconnect to the “ON”
position.
The temperature
inside of the mobile
unit is too warm.
4.
The Temperature Control
settings are correct.
Verify that the Temperature Control
for the Scan Room is set at 67 F and
the Control Room is set at 68 F.
Please contact Oshkosh Specialty
Vehicles for further assistance.
Problem:
Check for:
Solution:
1.
Check for open exterior doors
left open during cold weather
conditions.
The HVAC system can only support
the environment of the mobile unit.
Unless opened for use, all exterior
doors should remain closed all of the
time.
2.
Check for blocked or dirty air
vents and/or air conditioner
filters.
Clean the air vents and/or change the
air conditioner filters. After this has
been done, verify that warm air is
blowing.
3.
Check to see if the A/C
disconnect is in the “OFF”
position.
Turn the A/C disconnect to the “ON”
position.
The temperature
inside of the mobile
unit is too cold.
4.
The Temperature Control
settings are correct.
Verify that the Temperature Control
for the Scan Room is set at 67 F and
the Control Room is set at 68 F.
Please contact Oshkosh Specialty
Vehicles for further assistance.
