SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31215918
3-19
3.13 PLATFORM RAILS FOLD-DOWN PROCEDURE (IF
EQUIPPED)
ONLY FOLD DOWN THE RAILS WHEN THE MACHINE IS IN THE STOWED (PLATFORM
FULLY LOWERED) POSITION. DO NOT RAISE THE PLATFORM WITH THE RAILS FOLDED
DOWN. THE RAILS MUST BE IN THE UPRIGHT POSITION AND PROPERLY PINNED
WHEN RAISING THE PLATFORM.
The platform rails fold down from the mid-rail only, except for the rear
gate rail.
Platform with Rail-in-Rail Extension Deck
The platform rails fold down in the following sequence:
1.
Pull pin and fold REAR gate top rail in against RIGHT side rail.
Remove the platform control station and place on the floor
of the platform.
NOTE:
Front deck extension top rail pins must be removed and deck
extension top side rails slid towards rear of machine before low
-
ering side rails. Place pins in the lower holes of the extension side
top rails before folding main platform side rails down.
2.
Fully open the swing gate and hold while folding down the
RIGHT side rail.
3.
Fold down LEFT side rail.
4.
Fold down FRONT platform extension rail.
To raise the rails back to the upright position, unfold the rails in the
reverse sequence they were folded. Firmly pull the rails back up into
position and replace the bail pins into the rails.
AFTER THE RAILS HAVE BEEN FOLDED DOWN, USE EXTREME CAUTION WHEN EXITING
AND ENTERING THE PLATFORM. ENTER AND EXIT PLATFORM ONLY AT THE GATE AREA
AND LADDER PROVIDED.
IF DRIVING MACHINE WITH THE PLATFORM CONTROL STATION FROM GROUND, DO
NOT HANG THE CONTROL BOX ON ANY PART OF THE MACHINE WHILE DRIVING. HOLD
THE CONTROL BOX AND KEEP AT LEAST 3 FT (1 M) DISTANCE FROM MACHINE.
To
order go
to
Discount-Equipment.com
