Oshkosh JLG 520AJ, Operation And Safety Manual

Page: 39 / 112

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121664 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE APPLICATION AND
OPERATION. THE USER AND OPERATOR ARE RESPONSIBLE FOR CONFORMING WITH
GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: All machines are equipped with control consoles that use sym-
bols to indicate control functions. On ANSI machines refer to
decal located on the control box guard in front of the control box
or by the ground controls for these symbols and the correspond-
ing functions.
NOTE: The indicator panels use different shaped symbols to alert the
operator to different types of operational situations that could
arise. The meaning of those symbols are explained below.
Indicates a potentially hazardous situation, which if
not corrected, could result in serious injury or death.
This indicator will be red.
Indicates an abnormal operating condition, which if
not corrected, may result in machine interruption or
damage. This indicator will be yellow.
Indicates important information regarding the operat-
ing condition, i.e. procedures essential for safe opera-
tion. This indicator will be green with the exception of
the capacity indicator which will be green or yellow
depending upon platform position.