Section 3- Controls and Indicators
3
-
24
31211368
3.3 ANTI THEFT FUNCTIONALITY (IF ENABLED)
Machines with anti theft feature active require entering a numeric code before operation
to prevent unauthorized use. If multifunction display is installed, ant-theft feature is
accessed from that display only.
Note:
If the anti theft feature is active and the current access code is not known, it may be
viewed or changed by the machine owner (level 2 password may be required). See Service
Manual for information.
Instrument Panel Input
Code entry is accomplished using information provided in the instrument panel display.
1. Turn ignition switch to position 1. If anti theft is active, the display (
1
) will prompt the
operator for a numeric code.
2. Use the left button (
2
) to select the first digit. Press button to increase number.
Number will increase from 0 thru 9 then roll over to 0.
3. Press the right button (
3
) to confirm current digit and move to the next digit.
4. Continue until the code is complete.
5. If an incorrect code is entered, the display will prompt the operator again for the
numeric code.
6. If the correct code is entered, normal start up can continue.
Multifunction Display Input
If machine is equipped with Multifunction Display, refer to page 3
47 for anti-theft
functionality information.
OD1240
2
3
1
https://www.forkliftpdfmanuals.com/
