Section 3- Controls and Indicators
3
-
20
31211368
Load Stability Indicator - LSI (if equipped)
The LSI (
1
) provides visual and audible indication of forward stability limitations when
machine is static on firm, level surface.
• When approaching forward stability limitations LEDs progressively illuminate, green
(
2
), then orange (
3
) and finally red (
4
).
• If the red LED illuminates the warning buzzer also sounds.
The LSI has two modes:
Active Mode
• As the telehandler reaches forward stability limitations and the red LED (
4
)
illuminates, the automatic function cut
-
out is activated. All boom, frame level and
outrigger functions (if equipped) are disabled except for boom retract and boom
lift. Retract boom to re
-
enable functions.
Note:
When functions are cut-out, the LSI Override Switch can be used to temporarily
re-enable them. See “Left Dash Control Panel” on page 3
WARNING
TIP OVER HAZARD.
The LSI considers only longitudinal stability limitations, observe
all operating parameters. Failure to follow operating parameters of the telehandler
could damage the equipment and/or cause tip over.
OF0070
1
STOP
STOP
1001181531A
1001181531A
3
4
2
X
5
https://www.forkliftpdfmanuals.com/
