Oshkosh Corporation JLG R2632, Operation And Safety Manual

Page: 96 / 108

SECTION 6 - SPECIFICATIONS AND OPERATOR MAINTENANCE
6-18
31215932
6.9 DIAGNOSTIC TROUBLE CODES (DTC)
NOTICE
THE DTC CODES LISTED IN THE FOLLOWING TABLE IS NOT A COMPLETE LISTING OF
MACHINE DTC CODES. THIS LISTING SHOWS ONLY THOSE DTCS THAT AN OPERATOR
MAY BE ABLE TO CORRECT DUE TO OPERATING ERROR.
The DTC table following is sorted in groups by the first two digits,
these digits represent the number of flashes the system distress
indicator lamp will flash on the platform indicator panel when a
fault occurs.
The more detailed three to five digit code numbers in the DTC
column of the following tables are only indicated on a JLG hand -
held diagnostic analyzer connected to the machine, or on the
Ground Control Station - MDI indicator, if equipped.
To troubleshoot multiple DTCs, start with the DTC with the higher
first two digits.
I
f a correction is made during a check, conclude the check by
cycling the machine power off then back on, using the emer -
gency stop switch.
NOTICE
SHOULD A FAULT OCCUR WHICH CANNOT BE CORRECTED BY THE OPERATOR, THE
PROBLEM MUST BE REFERRED TO A QUALIFIED JLG MECHANIC.