Oshkosh Corporation JLG 450AJ, Service And Maintenance Manual

Page: 18 / 342

SECTION 1 - SPECIFICATIONS
1-4 – JLG Lift – 3121659
1.7 MAINTENANCE AND LUBRICATION
NOTE: The following numbers correspond to those in Figure 1-1.,
Maintenance and Lubrication Diagram - Deutz 2.3
Engine, Figure 1-2., Maintenance and Lubrication Dia-
gram - GM Engine, and Figure 1-3., Maintenance and
Lubrication Diagram - Deutz 2.9 Engine.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NOR-
MAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/
OR EXPOSED TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION
FREQUENCIES MUST BE INCREASED ACCORDINGLY.
1. Swing Bearing
Lube Point(s) - Fitting
Capacity - A/R
Lube - BG
Interval - Every 3 months or 150 hrs of operation
Comments - Apply grease and rotate in 90 degree inter-
vals until bearing is completely lubricated
2. Swing Bearing/Worm Gear Teeth
Lube Point(s) - Grease Fitting
Capacity - A/R
Lube - Lubriplate 930-AAA
Interval - A/R
Lube Point(s) - Grease Fitting
Capacity - A/R
Lube - Mobil SHC 007
Interval - A/R
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
DAMAGE TO OUTER SEAL IN HOUSING.
Table 1-14. Lubrication Specifications.
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of 350° F (177° C).
Excellent water resistance and adhesive qualities, and being of extreme
pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classification GL-5 or
MIL-Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104. Diesel - API
CC/CD class, MIL-L-2104B/MIL-L-2104C