SECTION 3 - BASE COMPONENTS
31215825
3-7
Wheel Drive Disassembly - Main Components
NOTE:
If possible, remove the wheel drive assembly from the
machine frame.
1.
Drain the oil from the Gearbox (1) by removing the cover
plugs in the cover.
2.
Remove the 2 Drive Motor Bolts (6) and slowly pull the
Motor (2) out of the gearbox.
3.
Obtain and install 2 bolts (M5 x 0.8 - 20mm long) into
the brake containment holes. This will keep the brake
housing in one piece.
4.
Cut the black wire tie (not shown) from the frame of the
motor.
5.
Remove the 3 Brake Bolts (7).
6.
Remove the Brake Housing (B1) and the Spacers (B4).
NOTE:
The brake wires will have some silicone sealant at the slot
through the motor flange. It is okay to pull the wire out of
the motor flange slot. The slot will have to be re-sealed
during reassembly.
7.
Remove the Brake Disc (B2) from the splined motor
shaft.
8.
Remove the Brake Friction Plate (B3) from the motor
flange.
Figure 3-8. Drive Motor Disassembly - Main Components
Go
to
Discount-Equipment.com
to
order
your
parts
