SECTION 6: MAINTENANCE
CAS40P 40 CFM / 100 PSIG
PAGE - 56
®
An Oshkosh Corporation Company
6.4.14 CHECKING HOSES AND WIRING
To maximize the accessible work space needed for
compressor unit maintenance, both side panels
(drive assembly access panel and instrumentation
panel) must be removed. Consult
Section 6.4.1.2,
Removing and Replacing a Side Panel
to remove
the side panels.
Hoses and wires are routed away from potential
pinch points, heat sources, and other hazards. How-
ever, when service is performed on a machine, it can
become necessary to cut zip ties or remove hose
clamps, which can allow hoses and wires to become
exposed to some hazards within the enclosure. Ver-
ify that no hoses or wires are near belts, exhaust, fan
blades, sharp edges, or other pinch points.
Hoses and wires should perform for the service life of
the product. Occasionally, a plug or hose end may
work itself loose over time. Check all the hose fittings
to see that there is no visible leakage.
6.4.15 SERVICING THE SYSTEM FUSE AND CIRCUIT
BREAKER
To access the machine area where the fuse and/or
circuit breaker are located, the instrumentation panel
must be removed. Consult
Section 6.4.1.2, Remov-
ing and Replacing a Side Panel
to remove the
instrumentation-side panel.
NOTE
For maintenance kit details on hoses,
refer to
Section 8.14, Hydraulic Hose
System
.
WARNING
Before performing maintenance:
Shut down machine, relieve all system
pressure and lock out all power, as per
the Safety Section of this manual. If
machine is hot, allow package to cool
before removing any panel.
NOTE THAT THE SYSTEM CAN BE
STARTED REMOTELY:
Always clearly tag the start-up
instrumentation against accidental
system start-ups during maintenance.
WARNING
Before performing maintenance:
Shut down machine, relieve all system
pressure and lock out all power, as per
the Safety Section of this manual. If
machine is hot, allow package to cool
before removing any panel.
NOTE THAT THE SYSTEM CAN BE
STARTED REMOTELY:
Always clearly tag the start-up
instrumentation against accidental
system start-ups during maintenance.
Manual #99905382 Rev 02
(JUNE 2018)
Summary of Contents for IMT CAS40P
Page 119: ...BLANK PAGE...
