Installation and operating manual for Alarm-control.plus page
9 (10)
Duration of the alarm pause
This parameter determines how long the alarm pause lasts when you press the button on the
front of the Alarm-control.plus. After the pause time has elapsed, the device automatically returns
to the active mode. The
button‘s illumination is blue during the pause.
The factory setting is 30 minutes. The maximum setting is 180 minutes.
Event log
The event log shows in text form all events and changes that have recently been made.
Climate sensor configuration
If a climate sensor is used, on this page you can:
- Correct the displayed values of the measured
temperature and humidity values.
- Set the alarm limits of climate measurements
Configuration of the water sensors
The water sensors are configured in this menu. The
following settings are possible:
- Assigning individual names for the sensors
- Selecting sensor type: pair of electrodes or float switch.
- Activation or deactivation of the alarm message of the
sensor in the event of leaks.
- To determine whether the respective sensor is present
Fuses
The following fuse is located on the motherboard:
A 0.25 A fuse protects the climate sensor connection
Factory setting
All parameters are reset to the factory setting by
pressing and holding the button next to the LAN
connection for ten seconds.
The following are the factory settings for important parameters required for a successful
connection of the device to a computer network:
IP address automatically (DHCP server) - yes.
Automatic internet time - yes.
Time zone - GMT + 1. (Central Europe). The required time zone must be set manually for correct
operation.
PIN for user access
– 1234
PIN for service access
– 5678
Resetting to the factory settings does not reset the statistical information on the operating hours.
All operational logs remain unchanged.
