Unpack and Installation
7
Chapter 3 Unpack and Installation
Unpack:
When unpacking the components of XCM-240 monitor, please verify that none
of the components listed in Table 3.1 are damaged or lack. If there is any
missing, contact your distributors or Beijing Osee Digital Technology Ltd. for it.
Table 3-1 Packing List
No.
Item
Quantity
1
Device
1
2
Pedestal with screws
1
3
Power cord
1
4
adapter
1
5
User manual
1
6
warranty card
1
Installation:
1.
Prepare for installation
Please follow the procedures below before installing XCM-240:
Check the equipment for any invisible damage that may have occurred
during transit.
Confirm all the items listed on the packing list have been received.
Remove all the packing material including electrostatic-resistant
packing.
Retain these packing materials for future use.
2.
Mount a XCM-240 in your desired location of a standard rack.
Adequate ventilation is required when installed to prevent possible
damage to the XCM-240.
3.
Connect required cables for signal input and output. For BNC
connections use 75
Ω
rated connectors.
4.
Connect 4.74A19V DC power source using the included power
cord.
5.
Connect the power cord to the power interface.
6.
Fasten the power protect accessory.
Summary of Contents for XCM-240
