Page 16
Installation and Operation Manual - Osburn 1700-I
ENGLISH
4. Operating the Insert
This wood heater has a manufacturer-set minimum low burn rate that must not be
altered. It is against federal regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating instructions in this manual.
Before using the insert, the following steps should be completed :
• Empty the combustion chamber and install the air control handle
(A)
with the set screw
(B)
as
shown below:
A
B
Figure 8: Empty the combustion chamber
Figure 9: Installing the air control wood handle
• Install the combustion chamber side bricks as shown below.
Figure 10: Install the Combustion Chamber Bricks
Figure 11: Combustion Chamber Bricks Layout
• Install the ash lip and the blower (see
«Appendix 1: Blower and Ash Lip Installation»
);
• Install the door overlay (see
«Appendix 2: Door Overlay Installation»
• Install the faceplate (See
«Appendix 4: Faceplate And Trims Installation»
).
The following step is optional :
• Install the fresh air intake (See
Summary of Contents for 1700-I
Page 2: ......
Page 6: ...Page 6 Installation and Operation Manual Osburn 1700 I ENGLISH CERTIFICATION PLATE...
Page 54: ...NOTES...
Page 55: ......
