WARNING
LED
Flush Mounts
MODEL
2400
-3CCT
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.
1.
LED
Flush Mount
s
are suitable for using in
damp
location
s
2.
Please keep the LED
Flush Mount
s
a
way
from any corrosive substance, and
please
use
dry
cloth
when you clean it
3.
LED
Flush Mount
s
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
CAUTION
Application Notice
1. RISK OF SHOCK — House electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember to:
A) Turn OFF the power supply at the fuse or circuit breaker box before you install the fixture
B) Double-check all connections to be sure that they are tight and correct
2. This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also designed to be installed in accordance with local electrical
codes. If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code
3. RISK OF CUTS — some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts
4. Account for small parts and destroy packing material, as these may be hazardous to children
5. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person
6. Terminal block and the suspending accessories are not included. Installation must be performed by a qualified person
Surface Mount Installation
1) Turn off the switch.
Screw the bracket to the
junction box and ceiling
2) Connect the lamp body
2)
wires with power cord
3
)
Push the lamp towards the
3)
ceiling and rotate the lamp
3)
to make the mounting
3)
plate and the lamp body
3)
fixed tightly
4
)
Turn on the switch to check
4)
if the lamp works normally
Semi-flush
Mount Installation
1) Turn off the switch.
Screw the
semi-flush
mounted bracket to the
junction box and ceiling
2) Connect the lamp body
2)
wires with power cord
3
)
Push the lamp towards the
3)
ceiling and rotate the lamp
3)
to make the mounting
3)
plate and the lamp body
3)
fixed tightly
4
)
Turn on the switch to check
4)
if the lamp works normally
