Operator's manual
Ch
ap
ter
:
U
se
19
3.
Firmware Update
This allows the user to update the laser's firmware using the USB key. Remove the USB key from the connector and insert it into a PC to copy
the update files.
DO NOT open OR edit these files for no reason!
Put the key back in the laser and select the Firmware Update button
Press the Upgrade button and follow the instructions that appear on the screen.
DO NOT disconnect or turn off the device during the update process.
After a few seconds the screen will go completely white and remain so for about 30 seconds until the upgrade is complete. After the update is
complete the initial screen appears requesting the user to power cycle the system. Check the successful firmware update using the Info button.
4.
Settings
This menu allows the user to set the date and local time.
5.
Check-up
Allows the user to view the temperature of critical components (pool and electronics), activate the liquid pump and check the liter reading of the
flow sensor and check the status and the number of full and partial shots of each lamp.
6.
Service
The service menu is protected by password and is accessible only to personnel authorized for the repair of the device.
7.
Cam
This button switches the view to the welding chamber, after a few seconds of inactivity on the touch screen the display automatically shows the
welding area; by touching anywhere on the touch screen the display returns to the Standby menu
Turn the key from O to I to start the work session. After the preliminary checks and the charging of the internal circuits has completed the
Operation menu will appear.
Operation menu
From the Home menu (Standby), turn the key to I (ON) to start the work session; at this point a screen appears with the message "Charging ..."
to indicate for the user to wait while the checks and preparations for starting work are being performed. Once this phase is completed, the
welder is ready, and the following operation screen appears:
Buttons 2 - 8 may be selected either from the touch-screen or the encoder located inside the welding chamber. To select a field with the touch
screen, press on the label of the parameter. To select a parameter with the encoder rotate up to highlight the desired parameter and press the
encoder to activate the parameter change; the field containing the value turns green when selected.
1
2
3
4
5
6
7
8
9
10
11
12
14
15
16
17
13
18