Operator's manual
Ch
ap
ter
:
U
se
18
- Brightness:
adjusts the brightness
- Contrast:
adjusts the contrast
- H position:
adjusts the horizontal hold of the image
- V position:
adjusts the vertical hold of the image
- Color:
adjusts the color percentage
- Tint:
compensates for tint errors with NTSC signals
- Sharpness:
adjusts the definition
Advanced Menu
- Sharpness:
adjusts the image definition
- Range:
sets the range correction between linear and CRT
- Color matrix:
enables or disables the ability to vary the color temperature
- Color temp:
adjusts the color temperature using preset settings
- User red/green/blue:
adjusts the temperature for every single color (function only
enabled when Color Matrix is selected)
Turning on the device
Move the power switch located on the front of the device to position I. Wait until the display shows the startup screen. Insert the enabling key
and turn it to position I. After a few seconds the welding parameters screen will appear.
Use the chamber adjustment controls to adjust the desired height, then set the desired parameters on the display according to the metal to be
welded. Use the control pedal to perform the welding.
Emergency Stop
The emergency button (see Ch. 14) is used to immediately switch off the device; This pulsed is equipped with a safety feature, once it is pressed
it must be pressed again to release it. Use the button only in case of danger or failure.
Example of practical use
This section describes practical use of the device and explains the laser welder menu.
Stand-by menu
At startup, the welding machine is in standby mode and the following screen appears:
The device status bar informs you of the device's status: Standby, Ready, the date and time of the work, etc.), and the status of critical
components of the device, such as for example, the temperature of the cooling liquid. This screen permits the selection of parameters such as:
1.
Select LANGUAGE
This menu allows the user to select the language for the device. Available languages are: Italian, English and Chinese.
2.
Menu INFO
This screen allows the user to view product information, in particular the firmware version currently installed.
1
2
3
4
5
6
7