Orolia Spectracom VelaSync 1232, User Manual

Page: 40 / 268

3.
Line up the rear of the inner rails at the chassis with the front of the outer rails at the
rack. Slide the server chassis into the rack, keeping the pressure even on both sides.
Depress the locking tabs, if needed (they will click upon proper engagement).
Figure 2-3:
Rack installation
2.4.1 TELCO Rack Installation
To install the VelaSync unit in a Telco-type rack, use two L-shaped brackets on either side
of the VelaSync chassis.
1.
Determine how far forward the unit will extend out of the front of the rack.
Determine a balanced front-to-back position of the chassis.
2.
Remove the bezel from the VelaSync. Attach the two front brackets to each side of
the chassis, then the two rear brackets, leaving just enough space to accommodate
the width of the telco rack.
3.
Slide the VelaSync into the rack, and tighten the brackets to the rack.
28
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4
2.4 Rack Installation