3.3.3.4 Setting GNSS Receiver Dynamics
Receiver Dynamics
further refine the reception characteristics for the individual receiver
modes and determine if the receiver will automatically resurvey after a reboot.
Caution:
If you select a setting that does NOT resurvey, and subsequently
relocate your unit (antenna) by more than 100 m,
u-blox M8T
receivers will
NOT detect the new position, and hence provide an incorrect time.
For more information about the
GNSS Survey
, see
"Performing a GNSS Receiver Sur-
.
For more information on
Receiver Modes
, see
"Selecting a GNSS Receiver Mode" on
.
To change/review the GNSS Receiver Dynamics:
1.
Navigate to
INTERFACES > REFERENCES: GNSS 0
.
2.
Under the
Main
tab of the GNSS 0 status window, the line item
Receiver Dynamics
will indicate the current setting.
3.
To change the setting, click Edit in the bottom-left corner. The GNSS 0 con-
figuration window will display:
4.
Select a setting and click Submit.
The following table illustrates the interdependence between Receiver Dynamics, Receiver
Mode (see
"Selecting a GNSS Receiver Mode" on page 129
) and receiver type:
Table 3-2:
Receiver dynamics, ~modes, ~ dynamics, ~ types
Receiver Mode
Receiver Dynamics
Land
(Resurvey)
Sea
Air
Stationary
(No Resurvey)
Single Satellite
irrelevant
irrelevant
irrelevant
irrelevant
132
CHAPTER
3
•
VelaSync 1232 User Manual Rev. 4
3.3 Managing References
Summary of Contents for Spectracom VelaSync 1232
