Orolia GSG-5 Series, User Manual With Scpi Manual, Page: 60 / 392

T h e s p e c i f i c a t i o n d e s c r i b e s t h e t r a j e c t o r y
a s f o l l o w s :
“The UE [User Equipment, (Orolia)] moves on a rectangular trajectory of 940 m by
1440 m with rounded corner defined in figure 1. The initial reference is first defined fol-
lowed by acceleration to final speed of 100 km/h in 250 m. The UE then maintains the
speed for 400 m. This is followed by deceleration to final speed of 25 km/h in 250 m.
The UE then turn 90 degrees with turning radius of 20 m at 25 km/h. This is followed
by acceleration to final speed of 100 km/h in 250 m. The sequence is repeated to com-
plete the rectangle.”
The complete specification can be found under
http://www.3gpp.org/DynaReport/25-series.htm
.
Circle : The user is moving in a circle throughout the scenario replay. When Circle is
selected, a dialog is shown asking the parameters describing this trajectory. These
parameters include diameter [meter], speed [m/s] and direction [clock-
wise/anticlockwise].
The start position of the trajectories is the position specified in the Configuration
View 1/3 , under Latitude, Longitude and Altitude.
3.5.4.2 User-Created Trajectories
GSG supports the simulation of custom-made trajectories. The trajectories are typically cre-
ated with the
GSG StudioView software (see also: "Creating a Trajectory in StudioView"
44 User Manual GSG-5/6 Series Rev. 27
3.5 "Select" Menu