To edit multiple cells at once, select the cells by holding down the Shift or Ctrl key while
clicking, and then click the
Edit
button.
4.9.16
Transmitting RTCM Messages With StudioView
The
RTCM Transmission
1
function allows to re-transmit RTCM message from the GSG
unit to the external receiver. In order to use this function, a virtual
Base Station
has to be
configured (see also:
) and used in your scenario, and the
external receiver has to be connected to the serial port.
1.
To open the RTCM Transmission window in StudioView, navigate to
Tools > RTCM
Transmission
or click
.
2.
Click
to open the Connections Manager tool (for details, see
.)
3.
Click
to configure the serial port, or use the dropdown menu.
4.
If required, specify the
Delay
in seconds.
5.
To start transmitting RTCM messages to the selected unit, click
.
The
button will appear, with a counter of all the RTCM messages
transmitted.
6.
To stop the transmission, click
.
See also these SCPI commands:
,
"SOURce:SCENario:RTCMCFG?" on page 299
and
1
Radio Technical Commission for Maritime Services
174
User Manual GSG-5/6 Series Rev. 27
4.9 Studioview Tasks
Summary of Contents for GSG-5 Series
Page 2: ......
Page 4: ...Blank page II User Manual GSG 5 6 Series...
Page 42: ...BLANK PAGE 2 5 Signal Power Level Considerations 26 User Manual GSG 5 6 Series Rev 27...
Page 382: ...BLANK PAGE 6 7 Revision History SCPI Guide 366 User Manual GSG 5 6 Series Rev 27...