numeric keys
to adjust the value, and then
enter
to confirm.
This sets the
Reference Power
which is used to control the absolute power
level of the GPS L1 C/A signal. You can also adjust the default relative power
offset
for each individual signal type other than GPS L1 C/A by selecting
Sig-
nals power configuration
. (For more information, see
.)
2.
While the scenario is running — by pressing the
N/S
key:
In Scenario Execution
Views 2 to 5/x
(see
) highlight
dBm
for all satellites, or press the
LEFT/RIGHT arrow
keys to highlight individual satellites. Then press the
N/S
key to adjust the
scenario power.
Note:
Pressing the
± (format)
key while dBm is highlighted
changes the frequency band to be adjusted: L1 > L2 > L5 >
ALL.
While this option will also open the
Transmit Power
menu (as under
1.
above), it is
used to adjust only the Transmit Power level for
the current scenario
(running now,
or in the future). All other scenarios will continue to use the default value, or the
value you set under
1
.
Note that the adjusted power level will also apply to any new satellites coming into
view later during any execution of this scenario.
3.
While the scenario is running — by pressing the press the
UP/DOWN arrow
keys:
In the Scenario Execution
Views 2 to 5/x
(see
) highlight
dBm
for all satellites, or press the
LEFT/RIGHT arrow
keys to highlight individual satellites. Then press the
UP/DOWN arrow
keys
to adjust the
Transmit Power
level, or enter a new value by using the
numeric keys.
114
User Manual GSG-5/6 Series Rev. 27
4.3 Setting Transmit Power
Summary of Contents for GSG-5 Series
Page 2: ......
Page 4: ...Blank page II User Manual GSG 5 6 Series...
Page 42: ...BLANK PAGE 2 5 Signal Power Level Considerations 26 User Manual GSG 5 6 Series Rev 27...
Page 382: ...BLANK PAGE 6 7 Revision History SCPI Guide 366 User Manual GSG 5 6 Series Rev 27...