42 | EdgeSync Manual rev 1
orolia.com
Show Alarms Command
show alarms
- This command will display any active EdgeSync alarms. If no alarms are present, the
Alarm Name and State columns will be blank.
Show Status Command
show status
- This command shows the Managed Clock Engine’s Sync information – EdgeSync
Sync Status and EdgeSync Sync State.
•
EdgeSync Sync Status can be either LOCKED or UNLOCKED.
•
EdgeSync Sync State can be one of the following: FREE RUNNING, SYNTONIZING,
SYNCHRONIZING, or HOLDOVER.
•
GNSS 1PPS Status can be either Stable or Unstable.
•
GNSS ToD Status can be either Stable or Unstable.
System commands
These are system-level commands.
System Info Command
system info
-The System Info command displays the basic system information – EdgeSync firmware
version, on-board oscillator type, Managed Clock Engine Firmware version, number of PTP slaves
supported and GNSS module type.
System Restore Command
system restore
- The EdgeSync System Restore command will restore factory default configuration.
System Upgrade Status Command
system Upgrade_Status
- The EdgeSync System Firmware Upgrade Status will be displayed if the
upgrade was initiated previously from either CLI or through Web User Interface.
System Upgrade Start Command
system Upgrade_Start
- The EdgeSync System Upgrade Start command will perform firmware
upgrade when the following inputs are provided:
•
File transfer protocol, 1 or 2 (for FTP or SFTP).
Note:
Option 1 (FTP) has been deprecated and is not available anymore
•
Hostname, as either IP address or DNS name
•
File name containing the upgrade FW
Network Commands
The Network Command operate on the Management port. The user can set up the network
parameters like enable/disable DHCP, static IPv4 address, netmask, and gateway addresses and display
the current setting of it. By factory default, the Management port network parameters are set statically
as follows:
