INSTALLATION
~60 mm
ORNO-LOGISTIC Sp. z o.o.
ul. Rolników 437, 44-141 Gliwice, tel. 32 43 43 110, www.orno.pl
PRODUCER
1.
This device is suitable for direct installation inside standard desk/table holes.
2.
Before you install the device inside a table, use hole saw (1) to drill proper holes in its surface. Hole diameter should be
approx. 6cm (2).
3.
Once the hole is prepared, turn the mounting ring left (3) and remove it.
4.
Put the power wire and the body of the socket inside the hole.
5.
Put the mounting ring through the power wire (3), tighten it up to the body of the socket and underneath the desk or table (4).
6.
Connect the power wire to the socket.
SAFETY AND MAINTENACE
Before any maintenance, switch off power supply.
Clean the device with soft and dry cloths only.
Do not use chemical cleansers.
Do not cover the product.
Provide free air access.
Protect the wires against breaking, tearing, excessive bending and other hazardous activities that can cause damage to the wiring
insulation.
4
Summary of Contents for OR-AE-13124
Page 2: ...2...
