TGPS-9084GT-M12 Series User
Manual
ORing Industrial Networking Corp
76
Disabled
: disable SNMP trap authentication failure
Trap Link-up and
Link-down
Indicates the SNMP trap link-up and link-down mode. Possible
modes include:
Enabled
: enable SNMP trap link-up and link-down mode
Disabled
: disable SNMP trap link-up and link-down mode
Trap Inform Mode
Indicates the SNMP trap inform mode. Possible modes include:
Enabled
: enable SNMP trap inform mode
Disabled
: disable SNMP trap inform mode
Trap Inform
Timeout(seconds)
Configures the SNMP trap inform timeout. The allowed range is 0 to
2147.
Trap Inform Retry
Times
Configures the retry times for SNMP trap inform. The allowed range
is 0 to 255.
5.5.2 SNMP Community Configurations
You can define access to the SNMP data on your devices by creating one or more SNMP
communities. An SNMP community is the group that devices and management stations
running SNMP belong to. It helps define where information is sent. A SNMP device or agent
may belong to more than one SNMP community. It will not respond to requests from
management stations that do not belong to one of its communities. This page allows you to
configure SNMPv3 community table. The entry index key is
Community
.
Label
Description
Delete
Check to delete the entry. It will be deleted during the next save.
Community
Indicates the community access string to permit access to SNMPv3
agent. The allowed string length is 1 to 32, and only ASCII characters
from 33 to 126 are allowed.
Source IP
Indicates the SNMP source address
Source Mask
Indicates the SNMP source address mask
