RGS-9244GP Series User Manual
ORing Industrial Networking Corp.
36
DHCP Client
Enable the DHCP client by checking this box. If DHCP fails or the
configured IP address is zero, DHCP will retry. If DHCP retry fails,
DHCP will stop trying and the configured IP settings will be used.
IP Address
Assigns the IP address of the network in use. If DHCP client
function is enabled, you do not need to assign the IP address. The
network DHCP server will assign the IP address to the switch and
it will be displayed in this column. The default IP is 192.168.10.1.
IP Mask
Assigns the subnet mask of the IP address. If DHCP client function
is enabled, you do not need to assign the subnet mask.
IP Router
Assigns the network gateway for the switch. The default gateway
is 192.168.10.254.
VLAN ID
Provides the managed VLAN ID. The allowed range is 1 through
4095.
DNS Server
Provides the IP address of the DNS server in dotted decimal
notation.
Save
Click to save changes
Reset
Click to undo any changes made locally and revert to previously
saved values
5.1.5 IPv6 Settings
You can configure IPv6 information of the switch in the page.
Label
Description
Auto Configuration
Check to enable IPv6 auto-configuration. If the system cannot
obtain the stateless address in time, the configured IPv6 settings
will be used. The router may delay responding to a router
solicitation for a few seconds; therefore, the total time needed to
complete auto-configuration may be much longer.
Address
Provides the IPv6 address of the switch. IPv6 address consists of
