User Manual
AQUATHUMP
W AT E R P R O O F S P E A K E R
1
2
3
4
5
Figure 1
DIAGRAM
(Figure 1)
1. Volume Down (short press)
Previous Track (long press)
2. Play / Pause (short press)
Power On/Off (long press)
3. Volume Up (short press)
Next Track (long press)
4. Micro USB Charging Port
5. 3.5 mm Audio Port
PAIRING YOUR SPEAKER
Turn on the speaker by holding the power
button
(Figure 1.2)
down for approximately 3
seconds; you should hear a power-up noise
and see a flashing blue LED light on the front
of the speaker to indicate that the device is
on and ready to pair. In the wireless pair
settings of your mobile device, connect to the
device named “Aquathump”. You will hear a
noise and see the blue LED light turn solid,
ensuring a successful pair. The speaker will
automatically turn off if no devices are paired
after 13 minutes.
To connect to a new device, (while turned
off) hold down the power button for 5
seconds until you hear two beeps. This tone
means it’s scanning for a new device.
CHARGING YOUR SPEAKER
Connect the USB charging cable to a power
source and insert the micro USB tip in the
charging port located underneath the port
flap. Let the Aquathump reach full charge
(approximately 2.5 hours if the battery was
completely drained) before use. The LED
light will turn red while the speaker is
charging, and turn off once fully charged.
PRODUCT FEATURES
• Wireless functionality with 33 foot range
• Up to 4 hours of audio playtime from a
single charge
• Built-in rechargeable battery
• Compatible with smart devices
• Waterproof when port flap is completely
sealed (submerged up to 1 meter)
• Carabiner clip for easy portability
