Backing Nails
Shelf
Screws
Shelf
Pins
Hanging
Brackets
freedomRail Garage Assembly Instructions
GOLocker
Contents of Package
Tools Required
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
(4)
(4)
Connector Bolts
(8)
(12)
(20)
Euroscrews
(2) Shelves
(2) Cleats
Bottom
Top
Middle
Left Side
Right Side
Locker Back
Assembling the GOLocker
Step 1: Attach Hanging Brackets, Shelf Screws, and Connector Bolts to Sides
Bottom Edge
Bottom Edge
(16)
Attach (4) Hanging Brackets to Sides using Euroscrews.
Attach (4) Shelf Screws and (4) Connecting Bolts near bottom.
(If using power rrill, set torque to low setting.)
Insert (6) Connector Bolts into small holes on Locker Top.
Step 2: Insert Connector Bolts into Top
Step 3: Attach Sides and Middle
(a) Attach Sides and Middle to Top. (b) Tighten Cams by turning
clockwise until snug.
Top
Lock
Cam
Open
Insert (2) Connector Bolts into small holes on Locker Bottom.
1
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Hammer
Left Side
Right Side
Locker Top
Smaller holes for
Connector Bolts
Step 4: Insert Connector Bolts on Locker Bottom
Locker Bottom
Align Arrow With Hole.
