Lock and Key
freedomRail Assembly Instructions
File Drawer OBox
Contents of Package
Tools Required
Power Drill
#2 Phillips
Screwdriver
Left Side
of OBox
(Inside View)
File Drawer Back
(Inside View)
Small Drawer Back
(Inside View)
Drawer Bottom
File Drawer
Right Side
File Drawer
Left Side
Small
Drawer
Right
Side
Small Drawer Front
File Drawer Front
(4)
(2) Drawer Pulls
Machine Screws
(For Drawer Pulls)
(4) Full Extension Drawer Glides
(32) Euroscrews
(4) 1 5/8" Wood Screws
(12) Connector Bolts
Hanging
Brackets
(2)
Right Side
of OBox
(Inside View)
Top
(Inside View)
Small
Drawer
Left
Side
Bottom
(Inside View)
#2 Phillips Driver
(2) File Folder Bars
O-Ring
Assembling the File Drawer OBox
Step 1: Attach Hanging Brackets
Step 2: Install Connector Bolts
Left Side
Right Side
Back Edge
Back Edge
Bottom
Install (4) Connector Bolts into small holes on Top and Bottom.
Step 3: Attach Sides
Cam
Lock
Open
(a) Attach Top. (b) Tighten Cams same as in Step 3.
(c) Place O-Ring over Lock from top and attach Lock with (2) Euroscrews.
Step 4: Attach Top and Locking Mechanism
Attach Hanging Brackets to Sides using Euroscrews.
(If using power drill, set torque to low setting.)
Top
Smaller Holes for
Connector Bolts
1
Over
(a) Attach Sides to Bottom. (b) Lock Cam by turning clockwise until snug.
O-Ring
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Align Arrow With Hole.
