ENGLISH
!"
Wireless Outdoor Temperature
and Humidity Sensor
MODEL: THGR328NH
USER MANUAL
CHANGE CHANNEL
Repeat the Set Up procedure. In Step 3, select a different channel number.
LOW BATTERY WARNING
The low battery indicator is shown on the main unit when the battery is low
for the selected remote unit. Replace the batteries whenever the low
battery signal
shows.
Do not use rechargeable batteries. Properly dispose used
batteries by taking them to an authorized disposal station.
RESET SYSTEM
The
RESET
button is located in the battery compartment. Press it whenever
you change the batteries, or whenever performance is not behaving as
expected (e.g., unable to establish radio frequency link with main unit).
Refer to the User Manual for the main unit for more information.
SAFETY AND CARE
Wash the unit with a slightly damp cloth and mild detergent. Avoid dropping
the unit or placing it in a high-traffic location.
Do not expose the unit to direct sunlight since this may affect the accuracy
of measurements.
WARNINGS
This product is designed to give you years of service if handled properly.
Observe the following guidelines:
·
Never immerse the unit in water. This can cause electrical shock
and damage the unit.
·
Do not subject the main unit to extreme force, shock, or fluctuations
in temperature or humidity.
·
Do not tamper with the internal components.
·
Do not mix new and old batteries or batteries of different types. Do
not use rechargeable batteries with this product.
·
Remove the batteries if storing this product for a long period of time.
·
Do not scratch the LCD display.
·
Do not make any changes or modifications to this product.
•
Unauthorized changes may void your right to use the product.
·
The contents of this user manual are subject to change without notice.
·
Images not drawn to scale.
TROUBLESHOOTING
Check here before contacting our customer service department.
PROBLEM
SYMPTOM
REMEDY
Temp
Main unit shows
Temperature is out of
“LLL” or “HHH”
range
Remote unit
Cannot locate main
Check batteries
unit
SPECIFICATIONS
Dimensions
L x W x H
70 x 24.5 x 116mm (2.76 x 0.96 x 4.57 inches)
Weight
156 grams (0.34lb.) with battery
Temperature
Unit
°
C or
°
F
Range
-20
°
C to 60
°
C (-4
°
F to 140
°
F)
Resolution
0.1
°
C (0.2
°
F)
Relative humidity
Range
25 % to 95 %
Resolution
1%
Frequency
RF frequency
315 MHz
Range
Up to 100 meters (328 feet) with no obstructions
Transmission
Approx 1 minute
Channel No.
1,2,3,4 or 5
Unit
°
C or
°
F
Power
2 X UM-3 (AA) 1.5V alkaline batteries
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more about Oregon
Scientific products such as digital cameras; MP3 players; children's
electronic learning products and games; projection clocks; health and
fitness gear; weather stations; and digital and conference phones. The
website also includes contact information for our customer care department
in case you need to reach us, as well as frequently asked questions and
customer downloads.
We hope you will find all the information you need on our website, however
if you're in the US and would like to contact the Oregon Scientific Customer
Care department directly, please visit:
www2.oregonscientific.com/service/support
OR
Call 949-608-2848.
For international enquiries, please visit:
www2.oregonscientific.com/about/international/default.asp
OMMR=lêÉÖçå=pÅáÉåíáÑáÅK=^ää=êáÖÜíë=êÉëÉêîÉÇK
MUSJMMuuuuJuuu
Check location
NOTE
NOTE
1
2
3
4
5
1
2
1
2
3
4
5
6
1
2
3
NOTE
ABOUT THIS GUIDE
Congratulations on your selection of the THGR328NH Oregon Scientific
TM
Wireless Outdoor Temperature and Humidity Sensor. This can be used
with new Oregon Scientific receiver units:
•
BAA998HGNH
•
BAA321HGNH
•
AWS888NH
•
BAA933HGH
•
BAA988HGH
Keep this manual handy as you use your new product. It contains practical
step-by-step instructions, as well as technical specifications and warnings
you should know.
PRODUCT OVERVIEW
FRONT VIEW
1.
LCD display
2.
LED status indicator
3.
Ventilation duct
LCD
1.
Low battery indicator
2.
Channel no
3.
Temperature (
°
C or
°
F)
4.
Relative humidity
5.
Temperature / Humidity reading
BACK VIEW
1.
Wall mount (recess hole)
2.
Channel switch
3.
Reset
4.
°
C/
°
F switch
5.
Battery compartment
6.
Fold-out stand
FOLD-OUT STAND
1.
Fold-out the stand
2.
Lock it into place
GETTING STARTED
This product can receive and transmit, outdoor temperature and humidity
then relay it back to the main (indoor) unit.
It can be used with up to 4 other remote thermo-hygro units to transmit
data to the main unit. The measurement unit (
°
C or
°
F) and channel number
(1,2,3,4 or 5) switches are located in the battery compartment, and should
be set prior to installation.
Additional remote units that measure temperature and humidity
are sold separately. If you are using more than one remote unit, be sure to
select a different channel number for each unit.
SET UP
1.
Place remote unit as close as possible to the main unit.
2.
Remove the battery compartment lid by using a Philips screwdriver
to loosen the screws.
3.
Assign a channel number. If you are using more than one remote
unit, select a different channel number for each unit.
4.
Insert the batteries. Match the polarity, as shown in the battery
compartment.
5.
Press
RESET
with the point of a blunt object (such as a ball point pen).
6.
Set the measurement unit.
7.
Replace the battery compartment lid. Secure.
8.
Position the remote unit using either the recess hole on the back of
the unit or the included stand. For best results:
·
Place the unit away from electrical or mechanical objects.
·
Place the unit out of direct sunlight and moisture.
·
Do not place the remote unit more than 100 meters (328 feet)
from the main (indoor) unit.
·
Position the unit so that it faces the main (indoor) unit. Minimize
obstructions such as doors, walls, and furniture.
You may need to experiment with various locations to get the best reception.
9.
Once the batteries are in place, the sensor will transmit signals every
60 seconds. The readings shown on the main unit depend on which
remote sensor (1,2,3,4 or 5) is selected. Refer to the Main Unit user
manual for more information.
The sensor range is 100 meters (328 feet) with no obstructions,
but if the main unit has a shorter range than the sensor, you may have to
move the sensor closer for reception.
!"#$%#&'(
qedoPOUke
!
!"
!"#
l ê É Ö ç å = p Å á É å í á Ñ á Å
q j
!"#$%#&'(
qedoPOUke
!"#$%&'()
lêÉÖçå=pÅáÉåíáÑáÅ=
•
B
^^VVUedke
•
B
^^PONedke
•
^tpUUUke
•
_^^VPPede
•
_^^VUUede
!"#$%&'()*+,-./0#1231245678
!"#$%&'()*+,-./01234
!
NK
i`a
OK
iba
!"
PK
i`a
NK
!"#
OK
!
PK
E
=çê=
F
QK
!
RK
=L=
!
NK
!"
=E
F
OK
!"#
PK
!
QK
E
=
=
F=
!
RK
SK
NK
!"
OK
!"
!
!"#$%&'()*+,*-./012
!"
Q
!"#$%&'()*+,-./012345
!"#$%&'(
E
=
F=
!"
EN
O
P
Q=
=RF
!"#$%&'()*+
!"#$%&'()*+,-+./012345
!"#$%&'()*+,$%-./012345
NK
!"#$%&'()*+,%-
OK
!"#$%&'(#$)*(+,-./
PK
!"#$%&'()*+,- !./01234567
!"#$%&'(
QK
!"#$%& '()*+ !,
RK
!"#$
=E
!"
F=
!"#$%&
SK
!"#
TK
!"#$ %
UK
!"#$%&'()*+$,-./01 !2345$
!"#$%&'
•
!"!#$%&'()*+,-./0
•
!"#$%&'()*+,-./
•
!"#!$%&'()"*+,-./
NMM
EPOU
F
•
!"#!$%&'()*+,-./0123456
!"#$%&
!"#$%&'()*+,-./'0123*
VK
!"!#$%&'()*+,-.
SM
!"#$%&
!"#$%&'()*
=EN
O
P
Q=
=RF=
!"#
!"#$%&'()*+,-./
!"#$%&'()!*+,-
NMM
EPOU
F=
!"#$%&'()*+,-./012345)6-789
!
!"#$%&'()*+,-./012345
1
2
3
4
5
1
2
1
2
3
4
5
6
1
2
3
THGR328NH_M.p65
2005.3.4, 11:09 AM
1