Hold tool rack in desired location, and use a pencil to mark holes
once level. Remove rack, drill holes and attach rack to wall
with hardware provided.
Note: You may need to move the tool holders to access the
mounting holes.
INSTALLING TOOL RACK
INSTALLING TOOL RACK
Adjust tool holders to chosen spacing on tool rack.
Tools will
“snap” into place when properly installed.
Snap-fit tool openings should face down.
To remove, press snap-fit tool buttons and pull tool out of tool
holders.
Allow a
minimum
of 45" clearance from floor to accommodate
length of wand and cleaning tool.
Hardware Included:
2 Screws: Flat Head screws
2 Anchors: For use in drywall, plaster or
wood paneling
Tools Needed:
#2 Phillips Screwdriver
¼” Drill Bit (if using anchors)
45
”
Model 521 521A00124
For use with BK51700 and BK11700 series
C
M
Y
CM
MY
CY
CMY
K
Oreck_ToolRack_Instructions_PRINT.pdf 1 1/31/18 4:34 PM
