3
Basic Operation:
When programmed as outdoor panel, input floor and room number (the digit is 3 at least), then
press
“
✓
”
to confirm. If you forget to press
“
✓
”
to confirm the input, it will call after 2 seconds
automatically.
When the room number is
＜
2 digits, you should press “
“
✓
”
” key to confirm the calling. When
programmed as wall station, input Building No. +
“
✓
”
+Unit No. +
“
✓
”
+room No.+
“
✓
”
button to call.
If the number is correct, the indoor monitor rings. If the number is incorrect or the indoor monitor
does not exist, the outdoor panel will display “Failure”. After 2 seconds, it will return to standby
mode.
If the indoor monitor is busy, the outdoor panel will display “Busy”, then auto return to standby
mode.
During a call, press “X” button on the outdoor panel, to hang up the call.
Management Centre Calling:
In standby mode, input (4 digits) “0000", then press
“
✓
”
key to call management centre. If success,
the outdoor panel will display “Calling”, the management centre rings.
If the number is incorrect or the management centre does not exist, the outdoor panel will display
“Failure”. After 2 second, it will return to standby mode.
If the management centre is busy, the outdoor panel will display “Busy”, then auto return to standby
mode.
During a call, press “X” button on the outdoor panel, to hang up the call.
Coded access unlocking:
Unlocking by access password
Press
“
✓
”
key, enter the access password (The default is 0000). Then press
“
✓
”
key to confirm. If the
password is correct, the door will be unlocked; if not, it will display “Password Err” on the display.
Unlocking by IC/ID card
Put the registered IC/ID card on card reader area of the outdoor panel. If successful, the door will be
unlocked.
