Orbitalum MOBILE WELDER OC PLUS, Operating Instructions Manual

Page: 44 / 204

ENGLISH MOBILE WELDER OC PLUS
44
ORBITALUM TOOLS GmbH , D-78224 Singen www.orbitalum.com
7.12.3 Resetting a password
All passwords can be reset using the super password.
The "Super Password" is located on the power supply data sheet supplied with the power supply.
To reset the password, perform the following steps:
1. Press the "Change Password" button on the login screen.
2. Press the "Change Admin Password" or "Change User Password" button.
3. Enter the super password in the "Old Password" input field.
4. Enter the new admin password in the "New Password" input field.
5. Enter the new admin password again in the "Confirm Password" input field.
7.13 User levels
The power supply supports two user levels:
1. Administration level - Full range of functions
2. User level - Limited range of functions
The distinction between the levels is made by means of the login password.
7.13.1 Administration level
At the administration level, the unrestricted range of function of the power supply is enabled.
Any system and program settings can be made and welding parameters can be adjusted.
Administrator password preset on the machine: 12345
At this level, you can additionally define a limit for the correction factor at the user level.
See the chapter Limit Adjustments [ } 132]
7.13.2 User level
When you log in at the user level, only the functions relevant to welding are accessible. The range of
functions in the software is tailored strictly to the user role.
User password preset on the machine : 54321