Orbitalum MOBILE WELDER OC PLUS, Operating Instructions Manual

Page: 160 / 204

ENGLISH MOBILE WELDER OC PLUS
160
ORBITALUM TOOLS GmbH , D-78224 Singen www.orbitalum.com
8.2.1.2 "Gas On" softkey
The "Gas On" softkey manually starts the gas flow and, if the ORBICOOL cooling unit is connected,
also the cooling flow.
When actuated again, the gas and cooling flow are stopped.
NOTICE By means of a manual start, the gas and cooling flow can be
checked independently of the welding process to ensure func-
tional readiness. An error message appears in the event of a lack
of gas or coolant.
8.2.1.3 "Permanent Gas" softkey
The "Permanent Gas" softkey starts the continuous flow of gas.
Pressing the softkey again stops the continuous flow of gas.
The permanent gas quantity can be defined in the system settings or in the "Gas Overview" under the
"Permanent Gas Quantity" menu item.
For further information, see the chapters Gas overview [ } 156] and System adjustments [ } 123]
8.2.1.4 "Back" softkey
The "Back" softkey takes you directly back to the "Weld Mode" menu.
8.2.2 Motor control
The "Motor Control" softkey takes you from the "Weld Mode" menu to a submenu where the weld head
rotation and cold wire functions can be controlled manually.
8.2.2.1 "Motor" softkey
The "Motor" softkey opens a softkey submenu with all rotation functions of the weld head:
MENU ITEM FUNCTION
"Jog Rotor CCW" softkey Rotates the weld head rotor counterclockwise.
"Jog Rotor CW" softkey Rotates the weld head rotor clockwise.
"Home Position" softkey Rotates the weld head rotor to the home position.
"Exit" softkey Takes you back to the "Motor Control" softkey menu.
8.2.2.2 "Wire" softkey