System Operation
Rebooting the ACU
OceanTRx
TM
4-500 Installation and Operations Manual
8-19
8.4
Rebooting the ACU
If the system did not start correctly or if you want to initialize the ACU, you can reboot
the system.
To reboot the system:
1. From the
Operation Screen
, open the
Commands
menu and select
Reboot
. A
confirmation message box appears.
2. Click
OK (Enter)
. The system reboots.
8.5
Configuring Host Hardware Interfaces
This section includes instructions on enabling the hardware and configuring
communication parameters of the following devices:
Compass
Satellite modem
GPS Input/output
Stow
IRD
Strength meter
All the operations are performed via the
Host Hardware Interface
dialog.
NOTE: In order to allow the CCU to communicate with the external hardware interfaces, the global
Enable Hardware parameter in the dialog must be set to
Yes
.
8.5.1
Host Hardware Interface Dialog
This dialog provides all the options to enabling interface to the external hardware
(compass, GPS, Modem, etc.)
To
view
the CCU Host Hardware Interface dialog
From the
Operation Screen
, open the
Host
menu and select
Hardware Interface
. The
Host Hardware Interface
dialog box appears.
Figure
8-18: Host Hardware Interface Enable Tab
Must always be
set to
Yes
for
during normal
operation
