Orban OPTIMOD-AM 9300, Operating Manual

Page: 87 / 242

OPTIMOD-AM DIGITAL INSTALLATION
2-41

Bypass : switches the Bypass Test Mode on the air.

Tone : switches the Tone Test Mode preset on the air.

Exit Test : If a test preset is presently on the air, EXIT TEST reverts to the
previous processing preset.

AM Mono from Left, Mono from Right, or Mono from Sum : Applies
the left channel, right channel, or sum (L+R) of the input audio channels
to the processing chain, which is monophonic.

Reset Clock To Hour : resets the internal clock to the nearest hour. For
example, 3:03:10 would be reset to 3:00:00, while 3:53:40 would be reset
to 4:00:00. Use this function to periodically re-sync the 9300’s internal
clock to your station’s master clock.

Reset Clock to Midnight : Resets the clock to 0:00:00. You can use this
function to periodically re-sync the 9300’s internal clock to your station’s
master clock.

Pass User Bits : Passes User Bits (as defined in the AES3 standard) from
the AES digital input through to the AES digital output.

Block User Bits

TX1/DAY : Recalls the
TX1/D
AY
transmission preset.

TX1/Night

TX2/Day

TX2/Night

No Function : remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.
Networking and Remote Control
[Skip this step if you do not wish to connect to your 9300 remotely, either for down-
loading software upgrades or for PC Remote Control.]
The 9300 has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps networks using the TCP/IP protocol. You can also connect a PC to the 9300
through the 9300’s RS-232 serial port, either by modem or directly through a null
modem cable.