Oracle X4 series, Administration Manual

Page: 97 / 240

Set SP Clock Properties (Oracle ILOM)
Oracle System Assistant either applies the changes or displays a message stating that the
changes cannot be applied until the next boot.
Set SP Clock Properties (Oracle ILOM)
Choose to configure the Oracle ILOM clock by either synchronizing the Oracle ILOM clock
with an NTP server or setting the date and time based on the local host time zone.
Before You Begin
Launch Oracle ILOM. For instructions, see “Accessing Oracle ILOM” on page 38 .
To modify the clock properties in Oracle ILOM the Admin (a) role is required.
The following procedure provides web and CLI instructions for both the server SP and CMM.
To modify the SP or CMM clock properties:
■
From the Web interface:
a. Perform one of the following:
■
To configure the clock properties to represent the local date and time that is
associated with the host operating system clock, configure the date and time
properties and then configure the time zone property. To do this, click ILOM
Administration → Date and Time → Clock -or- Timezone.
■
To configure the Oracle ILOM clock to synchronize with the date and time
associated with an NTP server, enable the property for synchronizing with an NTP
server and provide the IP addresses or host name of the NTP server(s). To do this,
click ILOM Administration → Date and Time → Clock.
b. Click Save to apply your changes.
■
From the CLI:
a. To set the date and time using the local host timezone, type:
set /
SP|CMM
/clock datetime=
MMDDhhmmYYYY
timezones=
3_to_4_characters
Performing Initial Setup Actions for Server Management 97