2.
Ensure that the appliance management interface is cabled for Internet connectivity.
3.
Connect the power cords to the Oracle Talari D2000. Connect the other ends to an
appropriately grounded power source. The Oracle Talari D2000 will power on
automatically.
4.
The Oracle Talari D2000 will begin the Easy 1st Install process. Please allow up to ten
minutes for the process to complete. (From the NCN Web Console, observe the
Configuration > Easy Install page for status updates during installation.)
5.
Once the Easy 1st Install process has completed, the Talari service will automatically be
enabled.
6.
To access the Management IP address of the Oracle Talari D2000 via the conduit after
deployment is complete, move the blue management cable to the LAN switch.
Installation Option: Manual Install
For use with Oracle Talari D2000 as a Router (Gateway, Fail to Block), Layer 2 Fail to Wire
(Overlay), MPLS and Internet Hybrid
Manual Install Site Deployment Criteria
Manual (Legacy) Install requires physical access to the appliance. The end user will require a
PC which can be connected to the console port of the Talari Appliance. The console port
connects the user to the Oracle ILOM command line interface. Cable management, LAN, and
WAN ports according to the Talari configuration for site.
Pre-Deployment Requirements
The network administrator must have an active configuration which includes a client package
for this site running on the NCN. An appropriate IP address, subnet mask, and gateway for the
management interface should be provided for the on-site user to configure.
If the network administrator will have access to the new appliance once an on-site user
configures the management interface, proceed to step 10 of Deploying the Talari Appliance. If
not, the on-site user will require the client package from the running configuration:
1.
From the Web Console of the NCN, navigate to Manage Network, and then Change
Management.
2.
Download the active package for the new client site.
3.
Send the zipped client package to the on-site user who will be deploying the appliance.
Deploying the Talari Appliance
1.
Connect the power cords to the Oracle Talari D2000. Connect the other ends to an
appropriately grounded power source. The Oracle Talari D2000 will power on
automatically.
2.
Connect the PC directly to the console port of the Oracle Talari D2000 and console into the
appliance using a bit rate of 115200/8-N-1.
3.
Log in to Oracle ILOM as an Administrator. To enable first time login and access to Oracle
ILOM, a default Administrator account and its password are provided with the system. To
build a secure environment, change the default password (Welcome1) for the default
Administrator account (root) after your initial login. You may change the password using
the command "set /SP/users/root/ password".*
Chapter 1
Installation Option: Manual Install
1-7
